APR Releases EA888 Gen 1 Stage III GTX Turbocharger System Share Comments APR is pleased to present the 2.0 TSI EA888 Gen 1 Stage III GTX Turbocharger System! In 2008, shortly after the worldwide release of the 2.0 TSI engine, Volkswagen of America commissioned APR to build the Stage III GT Turbocharger System for their SEMA concept cars. Successes of these concept cars lead to the first release of the APR Stage III Turbocharger System, based on the then available Garret GT turbocharger, and became a worldwide phenomenon. In the years since, APR has continued to work with VWoA, Volkswagen GmBH, VWVortex and BFGoodrich to deliver more concept cars for SEMA, Wörthersee in Austria, as well as other events around the world, while APR continued testing the latest in turbocharger technology. With the introduction of the Garret GTX2867R Turbocharger, APR has raised the bar further and redefined the standard by which the VAG community measures performance, reliability, drivability and quality. Gone are the days of compromise where low-end response meant excessive backpressure, compressor surge, and extremely limited top end performance. True to APR’s mantra of Performance without Compromise the days of shredding tires on front wheel drive vehicles are rapidly disappearing thanks to the new Gold Standard in ECU torque management calibration strategies only APR can deliver. APR’s endless pursuit of perfection has resulted in the most comprehensive 2.0 TSI turbocharger system in the world. The 2.0 TSI is completely transformed the second it meets an APR Stage III GTX Turbocharger System. Power immediately jumps to 423 horsepower with 387 ft-lbs of torque on tap using 93 octane fuel on a completely stock and unmodified factory fueling system. Switching to APR’s 100 octane race fuel mode, power shoots up to 458 horsepower with 409 ft-lbs of torque all at the driver’s command. This level of extreme performance is just a taste of the system’s full performance capabilities. APR’s Stage III+ GTX fueling system (Coming Soon!) increases performance further by simply adding a few bolt-on APR fueling components. Dyno Testing Horsepower and Torque was measured in APR’s in-house, soundmaster dyno cell, using a dynapack all-wheel dynamometer. Multiple stock and modified runs were conducted and the SAEJ1349 corrected results were averaged together to represent the differences between a stock and APR Stage III GTX 2.0 TSI. Crank power figures were estimated based on VAG’s factory advertised results. More information about the APR Stage III GTX Turbocharger System including additional photos and pricing information can be found on APR’s website.