AC and P/S delete? help Diy?

S

St.Olafmk3

· Registered

Joined May 20, 2013

·

83 Posts

Discussion starter · #1 · Dec 21, 2014

Only show this user

can someone redirect me to this diy with both the ac and ps delete. tried searching a bunch but couldnt find much. thanks

 

Z

zero.

· Registered

Joined Aug 14, 2001

·

7,629 Posts

#2 · Dec 21, 2014

Only show this user

Assuming it's for an ABA. Just remove all AC and Power Steering components, replace water pump pulley with a VR6 water pump pulley and run a 6PK 1033 or 1035 belt (either should work). You will have to leave the AC evaporator in unless you want to remove your dash to get to it.

You will want to drain most of the fluid out of the rack and only have a small amount in for lubrication. Your options there are to either loop the lines or just cap them off. EAA Engineering sells a loop: http://www.eaaengineering.com/steering-conversion-kits-lines/steering-de-power-conversion-kit/

I personally ran a capped rack for years with no issues. I don't think a loop would help out too much unless you have a lot of fluid in your rack still. I also later switched to a manual rack to pass inspection easier, and there was little to no difference compared to the capped power rack.

 

M

MK3JettaON

· Registered

Joined Oct 21, 2013

·

362 Posts

#3 · Dec 21, 2014

Only show this user

take of the ac and ps pump, 12v vr pulley you can use an mk3,mk4 one. and then for the belt - if you go a parts place that demands you give them a vehicle - say its for a 1998 toyota camary v6 with ac. (What i did)