Front Bumper repair

V

Valgus

· Registered

Joined Sep 20, 2003

·

3 Posts

Discussion starter · #1 · Sep 20, 2003

Only show this user

My buddy has a beautiful 337 and we are trying to improve its looks by removing its front licence plate panel. Here in Alberta we are not required to have front plates and would like to remove the ugly, black plastic plate. The problem is that when we removed it, there were two fairly large holes used for the screws. Does anyone have any experience with filling these and giving the front bumper a nice clean finish ? if so please advise.
TIA
Valgus

 

D

Der Wench

· Registered

Joined Aug 1, 2003

·

343 Posts

#2 · Sep 20, 2003

Only show this user

Re: Front Bumper repair (Valgus)

Go get a new strip at the dealer.

 

V

Valgus

· Registered

Joined Sep 20, 2003

·

3 Posts

Discussion starter · #3 · Sep 22, 2003

Only show this user

Re: Front Bumper repair (Der Wench)

Could you please explain what a " strip " is ?

 

S

secretaznman

· Registered

Joined Aug 28, 2002

·

3,878 Posts

#4 · Sep 22, 2003

Only show this user

Re: Front Bumper repair (Valgus)

Were the holes that were made for the lisence plate holder in the bumper itself, or in the rub strip on the bumper? If in the rub strip, just get a new rub strip as mentioned prior. http://****************.com/smile/emthup.gif

 

V

Valgus

· Registered

Joined Sep 20, 2003

·

3 Posts

Discussion starter · #5 · Sep 22, 2003

Only show this user

Re: Front Bumper repair (secretaznman)

The holes are actually in the bumper. Two fairly large ones (approximately one and a half cm wide) and two that are very small.