VW Vortex - Volkswagen Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. New Beetle & New Beetle Convertible
    Throwing p2450, p025c, and u0100 and going into limp mode. That's emission valve stuck, fuel pump circuit, and lost communication with ecm/pcm. Thinking maybe an electrical issue because I can't imagine all those things going at once. Does anyone have fuse diagrams for the '12 Turbo Beetle? It's...
  2. Touareg
    Hello there, I have a Touareg (specs above) with the following issues: 1. The idling: Best described as intermittently rough, especially as it warms up. 2. Rev cutting when the fuel temperature sensor is connected: With the fuel temperature sensor connected, I cannot rev the engine past...
  3. Golf/GTI VI
    Hey guys, I have a 2010 MK6 GTI DSG. It has a CTS k04 and IE Intake Manifold, running IE k04 IM 95 ron tune. It has a lot of mods. CTS Intake APR Coilpacks NGK plugs Milltek Turbo-back ECS FMIC + charge pipes + Turbo muffler delete REV D DV GFB DV+ (removed to try to fix this issue) IE Intake...
  4. Passat (B7)
    Hi all, I'm getting a code: 00545 Passive/Occasional (after about 30 mins of driving) for Throttle/Pedal Position Sensor/Switch B Range/Performance. Before getting this code I was getting code: 00290 for Throttle/Pedal Pos. Sensor A Circ. Low Input. I resolved this by checking voltage (on the...
  5. Automatic Transmission Forum
    Hi all - I have a 2017 Golf Sportwagen (which I love), SE 1.8T automatic, not DSG, ~117k miles, and for the past month it's been having an issue. About 8 or so times now, it's gotten itself stuck in 1 gear - usually 3rd gear, one time 5th gear. No lights come on, just gets stuck. If I stop...
  6. Golf V & Jetta V
    Alright so.. My gti goes into limp mode (turbo cuts off/no boost) when i drive in lower rpm, basically just normal driving at normal speeds, if i clear fault codes it drives really rough for a couple hundred meters then proceeds to drive as it should with boost, and I can keep it like that if I...
  7. The Volkswagen Lounge
    So picture below shows what I've done. First off I bought the car from a tow yard with no info on it. Did all the maintenance and stuff and couple days later I started goin to limp mode where I'll step on it , and it'll only make 5 psi. Scanned my car and had a p0420 code(cat below threshold...
  8. 2.5l Inline-5 Engine Forum
    Hello all, first time posting here as other threads haven't been much help. I drive a 2013 Volkswagen Jetta 2.5L. I have it tuned to IE Stage 1, a USP Engineering Cold Air Intake, Raceland Coilovers and Raceland exhaust cutout. A couple of weeks ago, the car started misfiring at high RPMs and...
  9. Golf V & Jetta V
    I have a 2009 Jetta with the 2.5l engine in it, and about 2 days ago my epc light and traction control lights came on and the car went into limp mode. But I didn’t have my code reader on me. Once I power cycled the car the epc light turned off and I had my power back. Yesterday when I was...
  10. Golf VII R
    Hi there I have seen this question everywhere, but I can't find any good answers. just bought a golf R 2014. on the way home from the dealer the EPC starts to light up on the highway. The car has 50hp now. scared as hell I turn off the road. stops the car, waits 5sec before I start again, and...
  11. Golf IV & Jetta IV
    need help. I had my ECU flashed with a stage one. After i swapped it out, i now am in limp mode. The code that i read says to look at the O2 sensor wires or the gas pedal. When i step on the brake pedal my RPM's increase. I have no throttle now. Has anyone ever encountered this? Please help.
1-11 of 11 Results
Top