VW Vortex - Volkswagen Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 31 Results
  1. 2.0 TSI & TFSI (EA888 Gen 1 & Gen 2) Engine Forum
    2006 gti engine harness, there are a group of electrical plugs close to each other in the wiring harness. green plug = knock sensor, grey plug = crank sensor, brown plug = knock sensor, one black plug = oil sensor on the filter housing… where does my last black plug go? It has 4 pin slots, only...
  2. Car Audio and Electronics
    I am in the process of retrofitting lane keep assist, an auto dimming mirror, and a rain/light/humidity sensor. Each one of those must be connected to a fuse. One of the fuses that is used by one of the three things I just mentioned is already occupied. This is expected, as VW lists multiple...
  3. Golf II & Jetta II
    Okay so who fancies a stab at this one :D Ignition on, indicators function normally, hazard switch functions normally. Ignition on and headlights on, indicators stay on and won't turn off again unless ignition turned off. I've looked at the wiring and all seems good. Tried testing the relay...
  4. Golf IV & Jetta IV
    Hello all, this is my second post as my first one kind of just turned into a Hodge podge of information, so im going to re-illiterate everything here. 2005 MK4 GTI, AWP engine w/ 09A trans. I picked up this car with the knowledge of it not running and to make it a project. Car cranks but does...
  5. Golf/GTI VI
    Help! I recently installed a hitch on my 2019 Golf Alltrack, with a manual transmission to tow very light loads. However, no one can figure out how to install the electrical harness to bring the signals from the brake and turn signals to the hitch for connection to the trailer (which I also...
  6. A6, S6, RS6, A7, S7, RS7 (C7)
    i need some help if anyone can lend a hand, i want to vr6 swap a c7 a6, i’ve seen some people on earlier models and a4s able to pin in sensors for swaps. do you think it being near in age, build, manufacturer, the engine wiring can be hand split, wired and pinned? all things considered in the...
  7. Jetta/GLI VI
    bought a jetta se 2.5 m/t in march love it so far gonna hopefully do som posts about work i’ve done soon wanted to replace the yellow incandescent bulbs above my license plate so i put led’s in. they didn’t work but at the time i didn’t have time to figure it out when i get around to it...
  8. Golf/GTI VI
    Just bought some smoked black vland taillights on my 2012 gti and I hate how they look. What I really wanted were the smoked red ones and Im willing to purchase another set but I am not willing to go theough the installation process all over again (took me 5 hours). So my question is if I...
  9. Golf I & Jetta I
    Can anyone point me in the direction of some wiring diagrams for an 83 GTI, Im trying to rewire the whole car, the majority of my issue is the ignition wiring, the harness that came with the car was spliced for a 1.8t and removed after the engine was pulled, so i just need a diagram or if...
  10. Jetta/GLI VI
    I've looked for hours and hours online and I can't seem to find any resource to help me. I have a 2012 Jetta SE with the 2.5L engine. I've been wanting to install the cool warning/puddle lights that I've seen all over this forum. I ordered the parts on AliExpress and they came after a few weeks...
  11. Hybrid/Swap Forum
    Hello everyone, Im hoping to get some insight on the current build im trying to cobble together. Quick backstory, I bought an 83 GTI that was in the process of having a 93 Cabrio 8v Digifant 2 engine installed, the engine is in and besides hooking up fuel, trans linkage, and finding an intake...
  12. Golf III & Jetta III
    I have a 94 Golf cabriolet that is getting a AGU 1.8T put into it. I had to drop the fuse box and disconnect a lot of wires to feed through the wall. Admittedly I have forgotten where they go or if some of these connectors were even used to begin with. Also ABS is throwing codes (possibly due to...
  13. Golf V & Jetta V
    Hello good afternoon, I'm installing a sunroof on the BCM of a Jetta MKV. I found 4 out of 5 wires. Positive, ground and 2 that go to the white plug of the BCM. But it has a white lilac wire that I don't know where it should be connected. Could anyone tell me? Thanks.
  14. Golf III & Jetta III
    Hello, This is my first post so I am unsure if I am uploading photographs properly. I replaced my heater core after it failed and I got a little too brazen when disconnecting the wiring harness under the dash and rebar as I removed the HVAC box. Can anyone identify these connections and...
  15. Golf V & Jetta V
    2007 GTI Fahrenheit With HID How would one about installing replacement halogen headlights into a car with HID headlight from factory. What pins go where in the connector? Are there harness kits available?
  16. Golf V & Jetta V
    I bought a pioneer ts-wx1210a sub with built in amp and noticed the wiring harness it came with has 18 gauge power and ground. I bought 8 gauge wire and was wondering why it came with such small wire? Also is it safe to connect them considering the size difference?
  17. Golf IV & Jetta IV
    Been having a lot of issues lately and among them is the front left blinker having what seems like no power at the moment. Was working 70% of the time and then just stopped. New bulb and still off. Won’t come on with hazards or when I lock or unlock to car from fob. The relay is still clicking...
  18. Golf/GTI VII
    Airbag has been acting sketchy for a couple weeks with passenger seatbelt alarm/signal going off when nothing is in passenger seat and passenger airbag light going on and off throughout drive. Got the car cleaned inside to remove a stain and as soon as I picked it up from the cleaner airbag dash...
  19. Touareg
    Fixed the dreaded corroded wires under the driver's floor issue and installed new battery. Engine light still on, engine responds super slow to throttle, brake warning lights on and flashing, and what looks like the cruise control light is on too (?). Any suggestions on how to solve this issue...
  20. Golf V R32
    Looking at a HU pinout diagram, it spits out 4 channels: L/R for front and rear. Are those signals already high level coming out of the HU, which the (Dynaudio) amp further splits out for the individual speakers? Tapping after the amp seems difficult, and if it was required I bet someone would...
1-20 of 31 Results
Top