VW Vortex - Volkswagen Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Does anyone have any info on this setup? I just finished building a 1.8jh motor with a light port job, tt 288 solid lifter race cam, kolbinschmit bearings, new rings, seals bla bla... and 16v pistons and was wondering if anyone had any imput. I was going to retro fit a knocksensor setup, but Colin from tt said it was not necessary as long as i run race or aviation fuel(planning to run 114 oct. av.). the motor is going in a 84 rabbit sedan with about 50K on the clock. any feedback is appreciated!!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top