VW Vortex - Volkswagen Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
I needed to replace the lower section of my exhaust (about mid body to tailpipe). I had some 2.25" pipe made for the replacement (since I will eventually change the entire setup to 2.25). It seems that no matter how I place the it is dangerously close to the rear brake lines. Any suggestions on fixing this. Extend the shield that goes between the underside of the car and the pipe? Don't worry about it because it can't burn through the brake line? Get braided brake lines? Help!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top