VW Vortex - Volkswagen Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
7,835 Posts
The glass transition temperature of PLA is around 60 deg. C. It can deform in a hot car when stress is place on it. (See my "Leaning Tower of Pisa" PLA printed GPS holder in an earlier post.)

If there is enough material in the knob, could it be possible to drill out the 20mm and re-tap to 23mm to fit on a 23mm shaft?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top