8v Digifant Dyno Printouts?

Re: 8v Digifant Dyno Printouts? (B3VR6)

http://www.clickhappy.com/ams.htm

Re: 8v Digifant Dyno Printouts? (clickhappy)

Thanks! Does anyone have a curve showing their chip optimized for Cams/Exhaust? ... or possibly any Dyno sheets that were done by fellow Vortexers and not AMS?

Re: 8v Digifant Dyno Printouts? (kickster)

Cool! Thanks for the curve. Is that the Autotech/HÖR Cam? (I just ordered one)
Whose header did you use and whose exhaust?
How about chip or possible Vane Air meter Spring mods?
Any head work?
Oh yeah.. any idea what was happening from 2700-3700 RPM on your car?
Sorry so many questions.. just trying to get an idea of what I'll be making with my setup when it's installed.


[Modified by B3VR6, 12:19 PM 2-12-2002]

Re: 8v Digifant Dyno Printouts? (Shawn O)

Got a mod list?
Cam?
Head work?
Chip?
Header/DO Manifold?
Exhaust?

Re: 8v Digifant Dyno Printouts? (Dub Envy)

Hmm.. what block code is that? Did you use a 3A bottom or an ABA? No cams or headwork yielded that much to the wheels? Sweet!

Re: 8v Digifant Dyno Printouts? (B3VR6)

Nice! That is crank HP I'm assuming?

Re: 8v Digifant Dyno Printouts? (kickster)

yikes...thats a little lean...guess thats the way the digi is...
Shaw O's A/F graph looks pretty nice....what were you running shawn O


[Modified by PAGTI91, 2:08 PM 2-12-2002]

Re: 8v Digifant Dyno Printouts? (PAGTI91)

Yes I have a 270 Autotech cam. No head work. the header is a Brospeed and exhaust is a 2.25 TT. No AMS chip.
The dip in the graph is due to running lean and knock sensor retarding the ignition. after 4K the knock sensor wont retard the ignition. (More fuel less knocking)

Re: 8v Digifant Dyno Printouts? (kickster)

It was an 1800cc block bored to 1.9. And yes, that figure is at the crank.

Re: 8v Digifant Dyno Printouts? (Dub Envy)

German digifant, Ported and polished head, Intake and exhaust ports match ported to gaskets, 5 angle valve job, 36.5 mm valve guides, 7mm crossflow head valves, Crossflow injectors,Schrick 276 cam, Autotech cam gear set at 6 degrees advance, AMS Digifant chip, Neuspeed intake, TT race downpipe & TT stainless exhaust (Borla with NO resonators). A/C deleted. Bosch WR7DTC plugs, Mk 3 exhaust manifold match ported to gaskets, intake manifold ported to match gaskets.....

Re: 8v Digifant Dyno Printouts? (Shawn O)

Holy CRAP! How much did all that head work cost? Sounds like a lot based on the price sheet I got from a local engine builder!