VW Vortex - Volkswagen Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
11,861 Posts
Discussion Starter · #1 ·
car has 88k it is an auto-
>car cranks
>new plugs,wires,cap,rotor,coil,blue temp sensor, digi control unit, FPR,
car has fuel, has spark, and air. It spudders a little bit when we try to crank it- it stumbles, but doesnt kick over.
Anyone have any ideas?
 

· Registered
Joined
·
11,861 Posts
Discussion Starter · #3 ·
Re: 91 Digifant 8v AUTO PROBLEM!!! (g60vwr)

well, we retimed it- everything was on- but which timing mark do you use on the head? we have been using the timing mark on the inside of the cam gear...
 

· Registered
Joined
·
1,013 Posts
Re: 91 Digifant 8v AUTO PROBLEM!!! (g60vwr)

thats the line on the inside of cam gear that lines up with the head -- turn the motor to TDC pull of the cap and check the rotor position --make sure its pointing to #spark plug wire in the cap -- --was the car running before replacing any parts --did you just buy it as non running ///
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top