[VEEDUBB1]

AM I doing this right? (020) flange

Excuse my terms... im not sure whats called what but im trying to press the cup on too the differential (the part were the drive axles bolt up too) Now in the picture you see my lovely bracket with the bolt through it that I was using to try and press the dirve axle cup thingy on too the diff shaft. Problem is that i cant clear enough space to put the washer then the circlip with out bending that angle plate that im using.

Now maybe the angle plate that im using to press it on is weak and the spring behind the cup is stonger. But b4 i mess something up in the diff I need somebody to comfirm what im doing is right. Or if they have a better way please to tell

 

[VEEDUBB1]

I cant push the flange in far enough to clear both circlip and washer. What if i chucked the washer and just inserted the circlip?

 

[VEEDUBB1]

There is no risk of blowing out the clips in the differectial by pulling the shaft against the flange? Last thing i wanna so is tear down the trans again! I was using a 1/4" plate and that thing was bending like a bannana! (not the one in the pic. I made another one)