Any problems with cutting stock valance?

351 Views 5 Replies 4 Participants Last post by sniper27, Dec 1, 2001

sniper27

Discussion Starter · Dec 1, 2001

I want to cut the stock valance for my Remus tips. I went to a muffler shop and they told me that if i did that, the rest of the valance, especially the middle part, will get weak and start to hang down and warp from the heat and stuff. Is that true? I've seen people do this, and are there any problems?
Thanks

Save

1 - 6 of 6 Posts

1BadAzzVR6

· #2 · Dec 1, 2001

Re: Any problems with cutting stock valance? (sniper27)

go for the clean look and get a 4mo valence. save the trouble.

Save

sniper27

Discussion Starter · #3 · Dec 1, 2001

Re: Any problems with cutting stock valance? (1BadAzzVR6)

eh, getting the remus put on this week. i seen stock valances cut out and looks clean. just not sure about what the muffler dude told me.

See less See more

Save

LSinLV

· #4 · Dec 1, 2001

Re: Any problems with cutting stock valance? (sniper27)

wheres the best place to get a 4 motion rear valance???

Save

blackGTI

· #5 · Dec 1, 2001

Re: Any problems with cutting stock valance? (sniper27)

hey Francis,
i cut my stock valence.. and there is no problem.....
the only problem is that you need to bring it to a place that knows what they are doing......if not they will screw it up.......
G luck

Save

sniper27

Discussion Starter · #6 · Dec 1, 2001

Re: Any problems with cutting stock valance? (blackGTI)

Chris, where did you go? I need to do it like this week. Thanks.

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month