BBS Rms with clipper kit, hot wide should i go?

377 Views 5 Replies 3 Participants Last post by LostBoyScout, Jul 2, 2003

cabbyracer

Discussion Starter · Jul 1, 2003

I want to have the lips of the wheels flush with the fenders. It seems like i would need the lips to be 1" wider in the front and 2" wider in the rear, but i'm not sure how the sizing is set up. If i ask for the 1" lips will i get the same size as the lips from the factory or will i get lips that are 1" wider than factory? ohh and if ur running htem please tell me what size ur running.

See less See more

Save

1 - 3 of 6 Posts

cabbyracer

Discussion Starter · #3 · Jul 1, 2003

Re: (cabrio_driver)

Well i don't think rubbing will be that much of a problem as i can adjust the suspension to the point where it won't rub, and will bring it back down to earth when i'm just cruizing. I love coilovers http://****************.com/smile/emthup.gif do you have the answer to my question though?

See less See more

Save

cabbyracer

Discussion Starter · #5 · Jul 2, 2003

Re: (cabrio_driver)

where r u rubbing on your 15x6 RAs? inside or outside? depending of the wheels ofset and width i've seen them rub in both places, but with RMs i have absolutly no problems with my car dropped to where it is right now, and if i had swaybars the rubbing problem would be less so. I can handle having to drive slowly around turns when on public roads, i'll just have to rais the car a little when i autocross.

Save

1 - 3 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month