VW Vortex - Volkswagen Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Installed turbo inlet and CAI this week (involved coolant hose replacement). Went for drive and noticed after that the coolant in expansion tank rose an inch over the max line. Was previously just below max line. Did not add any coolant post install. Two days later coolant is still at higher level and engine temps taking longer to cool between drives.

Air in line perhaps? Thoughts or suggestions welcome!
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #4 ·
Thanks dude. I've cycled as described a few times over the last couple days. Pumped the rad hoses as well. Have seen some drop in level but still high. Engine gets up to temp noticeably quicker now as well...will keep working it. Thanks for the response!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top