VW Vortex - Volkswagen Forum banner
1 - 1 of 4 Posts

· Registered
5,358 Posts
Re: Can anyone help me understand these OBD CODES? (hesseroni)

Is it running OK?
Maybe they just didn't clear the codes correctly.
Although your CEL light probably should have extinguished.
They may have been a tooth off when they changed your t-belt.
Engine speed sensor is located low on the block,by the clutch cable.
Cam position sensor is the Hall sender located on the side of your distributor

Modified by pjam at 8:47 AM 9-14-2005

Modified by pjam at 8:49 AM 9-14-2005
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.