VW Vortex - Volkswagen Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10,028 Posts
Syncro Prop Shaft will NOT work with Haldex trans/diff, the flanges are different.
Unless you get the rear diff from a Euro Sharan / Galaxy VR6, which has a Haldex style diff with a syncro viscous coupling attached :D But then you need the transfer case from a Skoda Octavia VRS.

Not that I'm over-complicating or anything ;)
 

·
Registered
Joined
·
10,028 Posts
I'm not 100% sure what you are getting at. From everything I have read I think I will need to put vr hubs on my car and drill them to 4x100. I'm not really sure though. :confused:
The splines on the actual driveshaft are the same between the the G60 and VR6, and from what Zach said they are the same on the 02M shaft as well. That means as long as you match your hubs and outer CV joints you can use either 4x100 or 5x100 as you please.
 

·
Registered
Joined
·
10,028 Posts
Cannot do 5x112 without custom hubs.
True. I'm working on it, and its a total PITA. I've not found anything 5x112 thats even close to fitting the Corrado :rolleyes:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top