VW Vortex - Volkswagen Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
I need replacement sealing washers (copper crush) where the Brake line connects to the rear left hand caliper. If you can provide a part number or perhaps where I can get them other than the dealership. I tried the dealership, however they only sell the entire line, banjo bolt w/ washers. Anyone know the specs of the washer....can they be purchased at autozone, or napa? Thanks
 

· Registered
Joined
·
32 Posts
Re: crush washers or (Vdubs)

By far the easiest place to get these is from a GM dealer
When you buy banjo fitted brake lines from cheap aftermarket suppliers (like when I did the 11.3" conversion on my Corrado), you need to get the washers. They are pennies a piece from GM, and they use the same metric sizes. Aaron
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top