VW Vortex - Volkswagen Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
9,130 Posts
Discussion Starter · #1 ·
I need to know if there is any kind of trimming necassary to fit this on? it goes on pretty damn hard.
 

·
Registered
Joined
·
9,130 Posts
Discussion Starter · #3 ·
Re: cullen vr6 chin (VEEDUBJETTA)

yea i was pretty sure there is minor trimming but I wasn't sure wear to trim.
 

·
Registered
Joined
·
3,510 Posts
Re: cullen vr6 chin (28)

the bottom lip of the actual bumper, u have to cut it straight across like 1/4 of an ich off.
dont cut off anything from the vr lip, just the bumper.
just keep shaving off the bumper until the clips fully clip in.
i used self tapping screws to make sure it dont go no where./
 

·
Registered
Joined
·
5,850 Posts
Re: cullen vr6 chin (Rampage GLI 16V)

quote:[HR][/HR]Here, with pics. this is what I'm using to install mine.
http://www.gti-vr6.net/library/body_exterior/Euro_GTI_fr_spoiler.html#mark6
Done, and done. This should also alleviate the "popping out" problem some have with their euro VR chins.[HR][/HR]​
thats a good one, i didnt notice that when i got my lip, the trimming was already done to the spoiler.
 
1 - 9 of 9 Posts
Top