[HappyVdubber2]

Can someone post pictures of their modified Euro Chin so that I can see what needs to be modified in order to make it fit nicely? I know that I will not be perfect.

 

[chrisreg]

Re: Euro VR6 Chin on a North American Bumper (HappyVdubber2)

quote:[HR][/HR]Can someone post pictures of their modified Euro Chin so that I can see what needs to be modified in order to make it fit nicely? I know that I will not be perfect.[HR][/HR]​

I'd like to see some too

 

[vr6willeatyou]

Re: Euro VR6 Chin on a North American Bumper (HappyVdubber2)

Me three...

 

[Lyzic]

Re: Euro VR6 Chin on a North American Bumper (vr6willeatyou)

look here for a very good guide + pictures on the installation.

 

[gti303]

Re: Euro VR6 Chin on a North American Bumper (vr6willeatyou)

gti-vr6.net has more then enough info

 

[Lyzic]

Re: Euro VR6 Chin on a North American Bumper (gti303)

quote:[HR][/HR]gti-vr6.net has more then enough info[HR][/HR]​

scooped ya on the reply !
also, the login for the site is driver , password is hired
this is just in case you can't see it on the login screen, where is says Realm:
Also, gti-vr6 has a ton of good info, it would be wise to bookmark http://****************.com/smile/emthup.gif http://****************.com/smile/emthup.gif

 

[chrisreg]

Re: Euro VR6 Chin on a North American Bumper (Lyzic)

nice, thanks a lot guys

What about the splash guards? Does replacing them place a big significance on the whole installation process?


[Modified by chrisreg, 5:35 PM 2-9-2002]

 

[HappyVdubber2]

Re: Euro VR6 Chin on a North American Bumper (Lyzic)

Thanks for the quick relpy guys!

In my attempts to fit the chin early last year, I have aleady cut away the corner piece. I haven't tried clipping the 3/4" off the bumper yet. If it still doesn't fit correctly, I will try and clip away the edges of the 5 tabs on the end (like he said is not nessesary).
Thanks Again,
Craig

 

[Lyzic]

Re: Euro VR6 Chin on a North American Bumper (chrisreg)

quote:[HR][/HR]What about the splash guards? Does replacing them place a big significance on the whole installation process?[HR][/HR]​

The splash guards are pretty basic to install, nothing compared to getting the chin to fit. I assume you are talking about the Euro splash guards, as the NA ones will fit, but not very well. Since the Euro kit was so expensive, i never ended up getting it. When summer rolls around I'll just rivet and epoxy some extensions to the NA one on, for $5 rather than $100+ or whatever Potterman sells them for.
But they are just held on by some screws and a couple tabs. Get under your car with a screwdriver and it'll take you seriously minutes to replace them all.