Euro VR6 Chin on a North American Bumper

402 Views 8 Replies 5 Participants Last post by Lyzic, Feb 9, 2002

HappyVdubber2

Discussion Starter · Feb 9, 2002

Can someone post pictures of their modified Euro Chin so that I can see what needs to be modified in order to make it fit nicely? I know that I will not be perfect.

Save

1 - 3 of 9 Posts

Lyzic

· #4 · Feb 9, 2002

Re: Euro VR6 Chin on a North American Bumper (vr6willeatyou)

look here for a very good guide + pictures on the installation.

Save

Lyzic

· #6 · Feb 9, 2002

Re: Euro VR6 Chin on a North American Bumper (gti303)

quote:[HR][/HR]gti-vr6.net has more then enough info[HR][/HR]

scooped ya on the reply !
also, the login for the site is driver , password is hired
this is just in case you can't see it on the login screen, where is says Realm:
Also, gti-vr6 has a ton of good info, it would be wise to bookmark http://****************.com/smile/emthup.gif http://****************.com/smile/emthup.gif

See less See more

Save

Lyzic

· #9 · Feb 9, 2002

Re: Euro VR6 Chin on a North American Bumper (chrisreg)

quote:[HR][/HR]What about the splash guards? Does replacing them place a big significance on the whole installation process?[HR][/HR]

The splash guards are pretty basic to install, nothing compared to getting the chin to fit. I assume you are talking about the Euro splash guards, as the NA ones will fit, but not very well. Since the Euro kit was so expensive, i never ended up getting it. When summer rolls around I'll just rivet and epoxy some extensions to the NA one on, for $5 rather than $100+ or whatever Potterman sells them for.
But they are just held on by some screws and a couple tabs. Get under your car with a screwdriver and it'll take you seriously minutes to replace them all.

Save

1 - 3 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month