Installing H&R Cup Kit tomorrow...question?

646 Views 2 Replies 2 Participants Last post by Drew10, Nov 29, 2001

Drew10

Discussion Starter · Nov 28, 2001

I have access to all the tools I would need. I will get an alignment right after, will install H&R sway bar for drive shaft clearance, I know you can't adjust camber on MkIVs... any suggestions?
The Bentley Manual says don't reuse #11 and #9, what did you do? My car only has 5,200 miles on it.

See less See more

Save

1 - 3 of 3 Posts

B3VR6

· #2 · Nov 29, 2001

Re: Installing H&R Cup Kit tomorrow...question? (Da_Wolf)

You should be fine. If it would make you feel better, go to the hardware store and get some Locktite.

Save

Drew10

Discussion Starter · #3 · Nov 29, 2001

Re: Installing H&R Cup Kit tomorrow...question? (B3VR6)

Thanks. After taking a look at it and whats involved in changing the front sway bar, I decided to get it done by a professional. I spoke to Larry from Macedo Motorsports about installing the stuff; hopefully when I call him in about a week he'll still be willing to do it.

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month