[98vr65202]

i have a H and R cup kit on my vr since like 40k ago but since i didnt change the bearings the first time when i installed the kit, i was stuck doing it again, my question is that the front is sitting quite a bit higher than before, is it gonna settle back down again? just makin sure the install is all good , thanks


Modified by 98vr65202 at 12:01 AM 9-8-2005

 

[EuroVR6Mk3]

Re: just finished with stut bearings.... (98vr65202)

it should settle after a little while.

 

[98vr65202]

Re: just finished with stut bearings.... (EuroVR6Mk3)

yea its what i fiugred, thanks http://****************.com/smile/emthup.gif

 

[XstartXtodayX]

Re: just finished with stut bearings.... (98vr65202)

It will settle a little bit but wont be as low as before, when strut mounts wear the rubber compresses, it can compress anywhere from 10-20mm, so with the new mounts you're looking at that much added to your height... some ppl measure the old vs the new to compare, I'm actually looking fwd to getting new ones to get my front up a bit.