VW Vortex - Volkswagen Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
532 Posts
Discussion Starter #1
I picked this up some time ago, to use on my 10vt project. I have decided to build a long tube header and go hy35. So its up for sale.

This turbo consists of a Porsche K26/6 turbine and exhaust housing, Audi K26 center, and turbonetics t04b compressor wheel and housing. It has had a fresh rebuild, and also balanced at GPop. It has never been installed. This should be a nice upgrade for any 10vt or 20vt. It it was built to be a direct bolt on, using the factory oil and coolant lines.




k26 on left, t04b on right



Here is the rotating assembly before being sent off for balance. I also opted to use the Audi K26 compressor dual seal ring collar.



I'm asking $500 plus shipping.

Thanks for looking
 

·
Registered
Joined
·
470 Posts
Was curious that's not for a 1.8t 20v is it? It doesn't look like it will bolt up to the factory exhaust manifold?
I have a 1999 a4 quattro.
Thanks
 

·
Registered
Joined
·
532 Posts
Discussion Starter #3
Sorry, this fits the Audi 2.2l 5 cylinder engine. It sold the same day as well too, sorry.
 
1 - 4 of 4 Posts
Top