VW Vortex - Volkswagen Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,524 Posts
Discussion Starter · #1 ·
I've been throwing a code for my MAF that the circuit is reading too high (Sorry don't have the exact code number on hand) I've gone through 3 known good MAF sensors and they didn't fix the problem. I have a miss at partial throttle and it completely kills the motor until I either give it more gas or let go.
I'm planning on doing the AEG manifold swap and have to extend the wiring. I saw a little slice in one of the wires going to the MAF sensor but it was only in the protective covering and not the wire itself. Should I just redo all the wiring, since I have to extend it anyway? The only thing I can think of is that theres a short or something somewhere. Any other help?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top