VW Vortex - Volkswagen Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
834 Posts
Re: OEM LED Installation (jimb)

Did you run the 2 new wires down 1 side (both on the drivers side?) and then across in the hatch area or one on each side (ie left down left side, right down right side). It wouldn't make a big difference unless it is easier to remove the hatch area trim than it is to run the right side wire behind the center console and glove box.


Modified by rickerbr at 9:57 PM 7-25-2007
 

·
Registered
Joined
·
834 Posts
Re: (linedpaper)

Where did you get your leds from? I've had an order with Dynamic Motorworks since 7/30 and they still don't have any. oempl.us didn't have any when I checked a couple of weeks ago.
 

·
Registered
Joined
·
834 Posts
Re: (Buran)

The OY and O8 flashes do not affect the CECM (Central Electronics Control Module). I don't believe either of them will make your bulb out warning go away. I have an 06 with just the OY update and I ran the extra wires and have never had any bulb out warnings (and my LEDs have been in for 9+ months now).
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top