VW Vortex - Volkswagen Forum banner
1 - 1 of 2 Posts

· Registered
29 Posts
Discussion Starter · #1 ·
Hello everybody,
I wanted to put an external oil cooler on a modified 85 1.8 8v motor. I was given this tansmission cooler for free with AN -4 fitting (1/4" inner diameter). Is the flow rate for this too low for my motor. Will I starve the motor from oil? Jegs and Summit racing catalogs have no oil coolers with that small of a fitting. Any ideas?
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.