VW Vortex - Volkswagen Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
100 Posts
Discussion Starter · #1 ·
So today I was working on replacing my battery cables and suddenly I noticed that there were some wires leading up to right underneath the rain tray. Turns out, my ox sensor is just hanging out there...
 

·
Registered
Joined
·
5,355 Posts
So today I was working on replacing my battery cables and suddenly I noticed that there were some wires leading up to right underneath the rain tray. Turns out, my ox sensor is just hanging out there...

The O2 Sensor wire is just pressed into the connector up by the Coil (single wire units anyway) and I've seen them get pulled loose from being snagged by road debris, etc.
 

·
Registered
Joined
·
100 Posts
Discussion Starter · #7 ·
Things aren't as bad as they originally seemed. I had forgotten that on 16v cars the sensor goes to the cat. And my cat was removed by the PO because it was clogged.

So should I completely disconnect it or should I be making a new place to mount it? Thoughts and ideas would be appreciated.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top