VW Vortex - Volkswagen Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
I got a error code p0011 after changing spark plugs and coils because I had a misfire car ran fine for 2 hours but then I start my car again it sounded like a misfire so I checked and I got code p0011 car ran like ass for 2 minutes but after it was warm car ran good is this normal what should I do?
 

·
Registered
Joined
·
293 Posts
The code you give is for the camshaft timing actuator which varies the intake cam angle via the oil control valve. Did you knock the wire to the oil control valve loose? You could simply have a poor electrical connection to the actuator, sticking actuator valve or low / dirty oil. keeping it simple, check the connection first.
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #3 ·
I might’ve after I changed coils I was checking stuff and might’ve made it loose I will check thanks! Also that was my other plan to change oil but the noise just stopped so I didn’t know what happend
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top