VW Vortex - Volkswagen Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
98 Posts
Discussion Starter · #1 ·
How do I check my ODB1 codes I have a 94 2.0 GL drove a trip of 380 miles and got back shut it off about two hours later started it later on and I have power but not like it was before i left or on the trip i filled my tank and it is still doing it i changed the cap and rotor and still the same thing it seem to sputter when i get above 2 grand then at 3 the check engine light comes on and when i shift it goes off any suggestions any one i want to flash the codes and see what the problem is i know where to check the codes but don’t know what the codes are or mean any one have a chart and what pins to check to flash the codes ?
would a cloged fuel filter do this ?
the tank was low when i got back it did this before i filled it up i thought it was low on fuel and running like crap
something cloges in my fuel filer or bad gas maybe



Modified by tony17257 at 5:21 PM 3-16-2008
 

· Registered
Joined
·
98 Posts
Discussion Starter · #2 ·
Re: qushtion about ODB1 (tony17257)

Ok with much searching i figured out how to check my ODB1 codes
i did it today and i got code#4412
the guy at autozone said it was injector #2

so we changed it
now i am getting code #4411 fuel injector fault
any suggestions or advice to fix this problem?
should i replace all 4 injectors with ones from a junk yard ?
any one ever have this problem?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top