[Memo6453]

are you guys using expanding nuts? or just self tapping to go into the bumper? i ordered the volvo bracket and curious if it brings hardware... if not, what do i need? and what size drill bits?

 

[Memo6453]

I just received my Volvo bracket... didn't bring the acorn nuts... where do i get some deep enough to make sure the plate is tight on the bracket? Home depot or lowes?

 

[Memo6453]

As others have said:
1. Volvo rear license plate bracket
2. Well Nuts
3. 10-32 stainless screws

You pick the size well nuts and screws. Here are examples. See post 33 below.

MEASURE 4 TIMES- then drill holes. Be sure you have proper spacing to center plate horizontally and vertically.
I used painter tape to cover bumper when drilling


https://www.amazon.com/MTC-VM680-30762264-License-Retainer/dp/B01CGNXP2I

https://www.homedepot.com/p/Everbilt-10-32-tpi-x-5-8-in-Brass-Expansion-Nut-814358/204276054

#33

thanks again. but im asking for the cap nuts that will actually screw onto the volvo bracket to secure the plate...im assuming your reply was in reference to my question. if not, i apologize.