Joined
·
411 Posts
As others have said:
1. Volvo rear license plate bracket
2. Well Nuts
3. 10-32 stainless screws
You pick the size well nuts and screws. Here are examples. See post 33 below.
MEASURE 4 TIMES- then drill holes. Be sure you have proper spacing to center plate horizontally and vertically.
I used painter tape to cover bumper when drilling
https://www.amazon.com/MTC-VM680-30762264-License-Retainer/dp/B01CGNXP2I
https://www.homedepot.com/p/Everbilt-10-32-tpi-x-5-8-in-Brass-Expansion-Nut-814358/204276054
#33
1. Volvo rear license plate bracket
2. Well Nuts
3. 10-32 stainless screws
You pick the size well nuts and screws. Here are examples. See post 33 below.
MEASURE 4 TIMES- then drill holes. Be sure you have proper spacing to center plate horizontally and vertically.
I used painter tape to cover bumper when drilling
https://www.amazon.com/MTC-VM680-30762264-License-Retainer/dp/B01CGNXP2I
https://www.homedepot.com/p/Everbilt-10-32-tpi-x-5-8-in-Brass-Expansion-Nut-814358/204276054
#33
