[Patrick Schmidt]

Hey guys,
I'm looking around for info on mounting the hall effect magnets in the crank pulley. I want to get it right the first time. There is a website that offers this service, but of course now that I need it, I can't find it. Could anyone point me in the right direction?
Thanks,
Pat

 

[oversteervw]

Re: SDS question (Patrick Schmidt)

http://www.sdsefi.com/emanual.htm
this is the complete manual for the EM-3 system. it has info for the magnets and hall sensor mounting.

 

[Patrick Schmidt]

Re: SDS question (oversteervw)

Thanks for the link. I've already ready the manual, but I just dont see how it is done on the crank pulley I have. The manual says that the holes for the magnets are not to go all of the way through the pulley. Looking at the crank pulley, there is not enough material to just make a pocket for the magnet to sit in.

 

[BUNNYLOVE]

Re: SDS question (Patrick Schmidt)

If you have a 16V crank pulley theres plenty of meat on the inside to drill. I had to use a 16V pulley instead of my old 8v one for this very reason.

 

[Patrick Schmidt]

Re: SDS question (BUNNYLOVE)

Thanks, I guess I'll take another look when I get home. Was it a real pain to do this? Like I said, this is something I'd like to get right the first time.

 

[BUNNYLOVE]

Re: SDS question (Patrick Schmidt)

Its not as bad as it looks. If you want I can take a picture of it and send it to you. email me if you want me to.
Good luck

 

[speed51133]

Re: SDS question (BUNNYLOVE)

here is my pully with hall sonsor on the power steering pully tensioner bracket.