this is bound to be a really easy answer.. but... help me out anyway?

370 Views 2 Replies 3 Participants Last post by Corrado Alley, Feb 8, 2002

g60_c

Discussion Starter · Feb 8, 2002

ok.. now this is pretty stupid post... i should be able to figure this one out.. but...
i've been scrapin my arms and hands all to hell for the last 20 min.. tryin to get the harness for my o2 sensor... OFF THE MOTOR MOUNT
i've got the two halves unplugged from one another, now i just wanna get the old one off that motor mount... i'm looking @ my new one right now... and it seems as though it just slides out sideways.. is there something i'm missin here?? anyone got a tip/trick for gettin that darn thing off?? any help would be appreciated!!
btw... 90 g60
thanks a mill everyone!
nate
while i'm @ it... i did a search for the correct diameter for the ecu-tb vac hose.. and every post seems to have come up w/a different diameter. someone said that a 3.5mm would work just dandy... can anyone verify this @ all?? or???
tahnks again

Save

1 - 1 of 3 Posts

jhignight

· #2 · Feb 8, 2002

Re: this is bound to be a really easy answer.. but... help me out anyway? (g60_c)

I just did this not too long ago. I'm pretty sure it just slides out sideways. I used a tiny flathead screwdriver to wedge between the inner lip of the bracket on the harness to start it, then it came off kind of easy. Maybe even tap the harness with the butt end of a driver (lightely, don't wanna break the harness, jsut the tension).
Good luck. Hope you're not having to replace the O2/engine harness itself! That's what I did...

Save

1 - 1 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month