VW Vortex - Volkswagen Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
582 Posts
Discussion Starter · #1 ·
i searched but couldn't find much. my car developed a pull the the left recently and it's more noticable at higher RPMs. suspected an engine mount and confirmed that today. the drivers side is completely shot and the front is not doing well
. i'm just gonna replace all of em since i think these are the original parts to the car.
what are my options? i wanna get something strong that's gonna last. i don't wanna spend a ridiculous amount but only good parts are used on my car. where to order also?

[Modified by shmaLbus, 12:13 PM 4-9-2002]


[Modified by shmaLbus, 12:13 PM 4-9-2002]
 

·
Registered
Joined
·
337 Posts
Re: vr6 engine mounts (shmaLbus)

http://****************.com/smile/emthup.gif on Turn2! I ordered the stage III kit and the stock tranny mount. Keep in mind, in addition to the Stage III kit, you might want to order an additional lower mount. If you desire, the rear mount housing can be seperated to install the lower turn 2.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top