[g0m3z]

Hi,
Just finished doing the VR6 swap into a 1995 Cabriolet and the car keeps stalling. It starts and engine just cuts off in couple seconds. Where should I start troubleshooting?
I already checked and double checked and triple checked the wiring, fuel lines are fine too.
I'm lost, PLEASE HELP!!!
What else should I check for?

 

[BORA RKT]

Re: VR6 Swap car stalling (g0m3z)

Sounds like a vaccum problem check your vac lines make sure they are all hooked up.

 

[g0m3z]

Ok, will do, are there only 2 pipes going from vac?

 

[g0m3z]

Could there be any kind of other problems?

 

[g0m3z]

bump