[Slow N Low]

getting some cams for my 97 vr6 soon and need a good place to go for the install as im not any good at engine work also how much roughly it shoudl cost for the job thanks

 

[Slow N Low]

Re: Where can i go and how much $ to expect? (RICHVR6)

was lookin at piper 264s

 

[Slow N Low]

Re: Where can i go and how much $ to expect? (RICHVR6)

420
whats wrong with them? i know schrick are the popular ones but why so much better?

 

[Slow N Low]

Re: Where can i go and how much $ to expect? (RICHVR6)

i had a kent 268 in my 96 8v and no problems
are you sayin the piper wont hold up for as long as the schrick?
i do like to get a good deal but im also willing to pay more for something that will work better id like all the imput i can get on this before i dump alot of money

 

[Slow N Low]

Re: Where can i go and how much $ to expect? (RICHVR6)

wow 600 sounds good
r u getting new lifters and springs and all that also?

 

[Slow N Low]

Re: Where can i go and how much $ to expect? (RICHVR6)

my car has 43k on it so im wonderin if anything would need to be changed with them?
also is 600 the going rate or is that because of the intake purchase and other hookups?

 

[corradub019]

Re: Where can i go and how much $ to expect? (SpdRacrGTiVR6)

http://forums.vwvortex.com/zerothread?&id=235881&postid=2021303#2021303
u should read this, these r the cams i'm getting, billet CAT 268's, 400 brand new. they r just as good as a set of schricks......so i've heard. i'm still looking in to them

 

[Slow N Low]

Re: Where can i go and how much $ to expect? (corradub019)

know anything of these rich?